2005 Arctic Cat ATVs factory service and repair manual, Page 218Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 218

19Remove three Phillips-head screws holding the oil pump and remove the oil pumpAccount for two alignment pins 17Remove the
I NOTE: Always use new snap ring when install- ing the oil pump driven gear 18Remove oil pump driven gearAccount for the
pin c AT THIS POINT To service clutch components, see Servicing Right-Side Components sub-section1- HOil Pumpfoil Strainer
I NOTE: Steps 1-18 in the preceding sub-sections must precede this procedure c AT THIS POINT To service center crankcase