2005 Arctic Cat ATVs factory service and repair manual, Page 228Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 228

CYLINDERICYLINDER HEAD ASSEMBLY I NOTE: If the cylinderlcylinder head assembly cannot be trued, they must be replaced Cleaningllnspecting
scoring, scuffing, warpage, and corrosionIf marks are found, repair the surface using cylinder hone (see Honing Cylinder
in this sub-section)Place the cylinder on the surface plate covered with #400 grit wet-or-dry sandpaperUsing light pressure,
move the cylinder in figure eight motionInspect the sealing surface for any indication of high spotsA high spot can be noted
by bright metallic finishCorrect any high spots before assembly by continuing to move the cylinder in figure eight motion
until uniform bright metallic finish is attained Water or parts-cleaning solvent must be used in conjunction with the wet-or-dry
sandpaper or damage to the sealing surface may result Water or parts-cleaning solvent must be used in conjunction with the
wet-or-dry sandpaper or damage to the sealing surface mav result Measuring Cylinder Head Distortion 1Remove any carbon buildup