2005 Arctic Cat ATVs factory service and repair manual, Page 235Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 235

3Install the pilot bushing with the machined end directed down; then fit the bushing into the pulley hub DRIVEN PULLEY ASSEMBLY
flat washer, and pilot bushing leaving the large spacer on the compressor tool base 5Place the holding handle on the spring
holder fitting the two dowel pins into the spring holder face; then install flat washer and the wing nutTurn the wing nut
down until resistance is feltI NOTE: Do not use the wing nut to compress the spring further 2Place the driven pulley assembly