2005 Arctic Cat ATVs factory service and repair manual, Page 242Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 242

Assembling 1234567891011Reverse Driven Gear Dog Reverse Driven Gear Circlip Bearing Countershaft Low Driven Gear Bushing
and washer are properly positioned; then secure with the circlip5Place the reverse driven gear dog onto the countershaft;
then secure with the circlipI NOTE: The countershaft is now completely assembled for installation 3Remove driven gear #2
from gear #I ;then account for large washer and keyInspecting 1Inspect the gear, pins, and keyway for wear2Inspect the springs
for damage or fatigueAssembling CRANK BALANCER DRIVEN GEAR :EY 2345678 1Place driven gear #2 into driven gear #1; then align
the alignment marks of driven gear #1 and driven gear #22Using pair of needle-nose pliers, insert each spring part way into
the slot; then install pin and push the springpin assembly into the slot 1Balancer Shaft Washer Driven Gear #I Driven Gear
#2 Spring Key Pin Washer 3Place the key and the large washer into position on the balancer shaft 4Place the driven gear #1