2005 Arctic Cat ATVs factory service and repair manual, Page 245Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 245

11Install the secondary and primary driveshaft assembliesAccount for the bearing alignment C-ring on the bearing boss next
half onto the left-side half 5In crisscrosscase-to-case pattern, tighten the mm cap screws until the halves are correctly
joined; then tighten to specificationsINOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 6In
crisscrosscase-to-case pattern, tighten the mm cap screws to specificationsMDI 336 Using plastic mallet, lightly tap the
case halves together until cap screws can be installedFrom the right side, install the crankcase cap screws noting the location
of the different-sized cap screws; then tighten only until snug INOTE: Rotate the shafts back and forth to ensure no binding