2005 Arctic Cat ATVs factory service and repair manual, Page 250Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 250

9Install two alignment pins and place the left-side cover gasket into positionInstall the left-side coverNoting the different-lengthed
wllock washer to specifications 7Install starter idler gear (No1) and starter idler gear (No2) 8Place the key into its notch;
then slide the rotor1 flywheel (with the ring gear in place) over the crankshaftTighten the nut to specificationsCCover DRecoil
StarterSteps 1-8 in the preceding sub-section must precede this procedure Tighten the cap screws (from step 9) in crisscross
pattern to specificationsPlace the gasket, recoil starter assembly, and cover into position on the left-side cover making