2005 Arctic Cat ATVs factory service and repair manual, Page 252Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 252

6Place the head gasket into position on the cylinderPlace the alignment pins into position; then place the head assembly
I NOTE: Steps 1-4 in the preceding sub-section must precede this procedure 5While keeping tension on the cam chain, place
the front cam chain guide into the cylinder 1 CAUTION Care should be taken that the bottom of the chain guide is secured
in the crankcase boss7Install the four cylinder head cap screws with washersNote that the two cap screws on the right side
of the cylinder head nearest the cam sprocket are longer than the two cap screws on the left (spark plug) sideTighten only