2005 Arctic Cat ATVs factory service and repair manual, Page 253Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 253

9In crisscross pattern, tighten the four cylinder head cap screws (from step 7) to specificationsTighten the two lower cylinder
the camshaft assembly is seated, ensure the following12With the alignment pin installed in the camshaft and the cam lobes
directed down (toward the piston), place the camshaft in position and verify that the timing mark on the magneto is visible
through the inspection plug and that the timing marks on the camshaft sprocket are parallel with the valve cover mating surfaceI
NOTE: When the camshaft assembly is seated, make sure the alignment pin in the camshaft aligns with the smallest hole in
the sprocket APiston still at top-dead-centerBCamshaft lobes directed down (toward the piston)CCamshaft alignment marks parallel
to the valve cover mating surface DRecessed side of the sprocket directed toward the cam lobesECamshaft alignment pin and
sprocket alignment hole (smallest) are aligned 13With the alignment pin installed in the camshaft, loosely place the cam