2005 Arctic Cat ATVs factory service and repair manual, Page 269Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 269

INOTE: Support the connecting rod with rubber bands to avoid damaging the rod or install the Connecting Rod Holder (pln 0444-006)
rotating it out of the groove c AT THIS POINT To service piston, see Servicing Top-Side Components sub-section To service
center crankcase components only, proceed to Removing Left-Side Components Left-Side Components I NOTE: For efficiency, it
is preferable to remove and disassemble only those components which need to be addressed and to service only those componentsThe
technician should use discretion and sound judgment Remove the flange nut securing the starter cup to the crankshaft; then
remove the starter cupAccount for the O-ring inside the cupUsing cold chisel, scribe mark showing the relative position of
the shift arm to the shift arm shaft to aid in installing; then remove the shift arm c AT THIS POINT To service any one specific
component, only limited disassembly of components may be necessaryNote the AT THIS POINT information in each sub-sectionI