2005 Arctic Cat ATVs factory service and repair manual, Page 270Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 270

5Loosen the clamps securing the coolant hose to the water pump; then remove the crossover tube from the cylinder headAccount
securing the water pump to the engine; then remove the water pump 9Remove the nut securing the magneto rotor to the crankshaft;
then install the magneto rotor puller adapterI NOTE: The puller has left-hand threads 10Using Magneto Rotor Remover Set (pln
0444-075), remove the rotorlflywheel assembly from the crankshaftAccount for the key; then remove the starter clutch gear
assembly and washer AT THIS POINT To service the water pump, see Section 4 7Remove the 13 cap screws securing the left-side