2005 Arctic Cat ATVs factory service and repair manual, Page 279Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 279

INOTE: Whenever valve is out of tolerance, it must be replacedCleaningllnspecting Valve Cover I NOTE: If the valve cover
of the sealing surface or damage to the camshaft will resultAlways check camshaft clearance when resurfacing the valve cover
Inspecting Primary OneInspecting Oil Pump 3-238 Driven Pulley Assembly3-238 Servicing Center Crankcase Components 3-242 Secondary
Gears 3-242 Crankshaft Assembly 3-243 Countershaft 3-245 Servicing Top-Side Components I NOTE: Whenever part is worn excessively,
cracked, or damaged any way, replacement is necessary Water or parts-cleaning solvent must be used in conjunction with the
wet-or-dry sandpaper or damage to the sealing surface may resultRemoving Valves I NOTE: Keep all valves and valve components
as setNote the original location of each valve set for use during installationReturn each valve set to its original location
during installation VALVE ASSEMBLY When servicing valve assembly, inspect valve seats, valve stems, valve faces, and valve