2005 Arctic Cat ATVs factory service and repair manual, Page 286Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 286

2Inspect the cylinder for pitting, scoring, scuffing, warpage, and corrosionIf marks are found, repair the surface using
honing oil is not available, use lightweight petroleum-based oilThoroughly clean cylinder after honing using soap and hot
waterDry with compressed air; then immediately apply oil to the cylinder boreIf the bore is severely damaged or gouged, replace
the cylinder- Inspecting Cam Chain Guide 1Inspect cam chain guide for cuts, tears, breaks, or chips2If the chain guide is
damaged, it must be replacedHoning Cylinder 1Using slide gauge and dial indicator or snap gauge, measure the cylinder bore
diameter in three locations from top to bottom and again from top to bottom at 90' from the first measurements for total
of six measurementsThe trueness (out-of-roundness) is the difference between the highest and lowest readingMaximum trueness
(out-of-roundness) must not exceed specifications 4If any measurement exceeds the limit, hone the cylinder and install an
oversized piston or replace the cylinderoversized piston and rings are available- oversized piston rings marked for and are