2005 Arctic Cat ATVs factory service and repair manual, Page 290Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 290

1If removed, insert the spiral spring into the case with the outer end of the spring around the mounting lug in the case;
50 cm (20 in of rope free of the reel spring end up and outHold the remainder of the spring with thumbs and alternately release
each thumb to allow the spring to gradually release from the case 3Apply low-temperature grease to the spring and hub 10Unwind
the rope from the reel and remove the ropeCleaning and Inspecting cracked, or damaged in any way, replacement is necessaryI
NOTE: Whenever part is worn excessively, 4Thread the end of the rope through the guide hole of the case; then thread the
rope through the handle and secure it with double knotInstall the protective cover into the handle5Align the inner hook of
the spiral spring with the notch in the reel Clean all componentsInspect the springs and ratchet for wear or damageInspect
the reel and case for cracks or damageInspect the shaft for wear, cracks, or damageInspect the rope for breaks or frayingInspect