2005 Arctic Cat ATVs factory service and repair manual, Page 293Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 293

3Install the pilot bushing with the machined end directed down; then fit the bushing into the pulley hub The spring assembly
turn as the spring holder clears the flats or hubThis is due to slight counterclockwise preload on the spring 5Place the
holding handle on the spring holder fitting the two dowel pins into the spring holder face; then install flat washer and
the wing nutTurn the wing nut down until resistance is feltI NOTE: Do not use the wing nut to compress the spring further
8Release the preload slowly; then continue to relax the spring until the wing nut is flush with the end of the threads9Firmly
holding the spring and spring holder, remove the wing nut; then remove the spring Page: 293 Arctic Cat ATV 2005 -All Models