2005 Arctic Cat ATVs factory service and repair manual, Page 296Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 296

Servicing Center Crankcase Components I NOTE: Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance,
the spring while guiding the spring holder onto the hubWhen slight resistance is felt, stop turning the wing nut10Install
the nut (threads coated with red Loctite #271); then tighten the nut to specification using the spanner and torque wrench
4While rocking the driven bevel gear back and forth, note the maximum backlash reading on the gauge5Acceptable backlash range
is 0.05-0.33 mm (0.002-0.013 inCorrecting Backlash INOTE: If backlash measurement is within the acceptable range, no correction
is necessary 1If backlash measurement is less than specified, remove an existing shim, measure it, and install new thinner
shim2If backlash measurement is more than specified, remove an existing shim, measure it, and install thicker shimI NOTE:
Continue to remove, measure, and install until backlash measurement is within toleranceNote the following chart 11Remove
the wing nut, washer, and holding handle; then remove the driven pulley from the pulley compressor Backlash Measurement Under