2005 Arctic Cat ATVs factory service and repair manual, Page 297Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 297

Checking Tooth Contact ary driven bevel gear, it necessary to check tooth contactI NOTE: After correcting backlash of the
1If tooth contact pattern is comparable to an incorrect pattern, correct tooth contact according to the following chartTooth
Contact Contacts at TOD Shim Correction 1 Contacts at Root Decrease Shim Thickness Increase Shim Thickness INOTE: To correct
tooth contact, steps and (with NOTE) of "Correcting Backlash" must be followed and the above "Tooth ContactIShim Correction"
chart must be consulted A CAUTION Incorrect (contact at tooth root) After correcting tooth contact, backlash must again be
checked and corrected (if necessary)Continue the correcting backlashlcorrecting tooth contact procedures until they are both
within tolerance values CRANKSHAFT ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter) 1Insert snap gauge into