2005 Arctic Cat ATVs factory service and repair manual, Page 298Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 298

2Maximum diameter specifications Measuring Connecting Rod (Small End Deflection) 2Mount dial indicator and base on the surface
feeler gauge, measure the gap between the connecting rod and crankshaft journal 3Zero the indicator and rotate the crankshaft
slowly Care should be taken to support the connecting rod when rotating the crankshaft 4Maximum runout must not exceed specificationsI
NOTE: Proceed to check runout on the other end of the crankshaft by positioning the indicator contact at point and following
steps 2-4 Measuring Crankshaft (Web-to-Web) 1Using calipers, measure the distance from the outside edge of one web to the
outside edge of the other web 3.Acceptable gap specifications Measuring Connecting Rod (Big End Width) 1Using calipers, measure