2005 Arctic Cat ATVs factory service and repair manual, Page 299Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 299

COUNTERSHAFT 2Remove the reverse gear dog; then remove the circlip securing the reverse driven gear When disassembling the
(L) Countershaft Low Driven Gear Bushing High Driven Gear Sliding Dog Drive Gear #2 Washer Bearing Reverse Driven Gear Reverse
Gear Dog Circlip Lock Washer Lock Washer 1Place the high driven gear onto the countershaft making sure the bearing, bushing,
and washer are properly positionedSecure with the circlip 4Place the reverse driven gear onto the countershaft making sure
the bearing, bushing, and washer are properly positioned; then secure with the circlip5Place the reverse gear dog onto the
countershaft; then secure with the circlip 2Place the sliding dog onto the countershaft; then secure with the circlipPlace
the washer next to the circlip 3Place the low driven gear onto the countershaft making sure the bearing and bushing are properly
positioned; then place the lock washers and washer onto the shaft 6Place drive gear #2 onto the countershaftI NOTE: When