2005 Arctic Cat ATVs factory service and repair manual, Page 301Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 301

I NOTE: It will be necessary to rotate the crank balancer until the counterweight is facing away from the crankshaft; then
the shift cams Place washer on each end of the countershaft assembly; then install the assembly 10Install the reverse idler
gear assembly noting the positioning of the two washers, gear, bushing, and shaftCC674 Install the driveshaft Place washer
on each end of the gear shift shaft; then install the shaft assembly making sure the two holes on the end of the shaft are
positioned verticallyPage: 301 Arctic Cat ATV 2005 -All Models 11Install the front and rear secondary driven shaft assemblies
into the left side of the crankcase making sure the bearing locating pins are facing upward and the bearing C-ring is fully