2005 Arctic Cat ATVs factory service and repair manual, Page 303Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 303

INOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 9In crisscrosscase-to-case pattern, tighten
liberal amount of grease, assemble the shift cam stoppers; then install them into the top of the engineI NOTE: The grease
will hold the springs and cam stoppers in position while installing the assemblies into the engine 6From the left side, install
the remaining mm cap screws (two inside the case); then tighten only until snugINOTE: Rotate the shafts back and forth to
ensure no binding or sticking occurs 7From the left side, install the eight case half mm cap screws; then tighten only until
snugINOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 8From the right side, install the mm
cap screws; then tighten only until snug W AT THIS POINT After completing center crankcase components, proceed to Installing
Right-Side Components, to Installing Left-Side Components, and to Installing Top-Side Components Page: 303 Arctic Cat ATV