2005 Arctic Cat ATVs factory service and repair manual, Page 306Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 306

14Slide the fixed drive face onto the shaft15Spread the faces of the driven pulley by pushing the inner face toward the engine
are in their proper locationTighten the cap screws to specifications 16Place the V-belt into position on the driven pulley
and over the front shaft Installing Left-Side Components IPlug the oil passage in the crankcase housing prior to installing
the drive gearldriven gear assembly to prevent loss of an alignment pinI NOTE: The arrows on the V-belt should point for-
17Pinch the V-belt together near its center and slide the spacer and movable drive face onto the shaftSecure the drive face
with nut (threads coated with red Loctite #271)Tighten the nut to specifications 1Install the water pump drive gear alignment