2005 Arctic Cat ATVs factory service and repair manual, Page 307Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 307

4In order on the crankshaft, install washer, ring gear, key, and the magneto rotorSecure with the nut (threads coated with
into position on the crankshaft making sure new, lubricated O-ring is inside the cupTighten the flange nut to specifications
I NOTE: The sharp side of the snap ring should be facing outward I NOTE: Once the gears are secured, remove the oil passage
plug from the crankcase 3Install the two starter gear shafts; then install the two starter gears (with the beveled side of
the intermediate gear facing inward as noted in removing) 8Tighten the cap screws (from step 6) to specificationsPlace the