2005 Arctic Cat ATVs factory service and repair manual, Page 311Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 311

11With the timing inspection plug removed and the chain held tight, rotate the crankshaft until the piston is at top-dead-center12With
install the five cylinder head nuts10In crisscross pattern, tighten the four cylinder head cap screws (from step 8) to 3.8
kg-m (27.5 ft-lb); then tighten the mm nut (from step 9) to 2.5 kg-m (18 ft-lb)Using crisscross pattern, tighten the mm nuts
(from step 9) to 1.1 kg-m (8 ft-lb)Tighten the two cylinder-to- crankcase nuts (from step 4) securely 14With the cam lobes
directed down (toward the piston), maneuver the camshaftlsprocket assembly through the chain and towards its seating position;
then loop the chain over the sprocketI NOTE: Note the position of the alignment marks on the end of the camshaftThey must