2005 Arctic Cat ATVs factory service and repair manual, Page 314Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 314

28Install the four top side cap screws with rubber washers; then install the remaining cap screwsTighten only until snug
the valve adjuster dial in place, use the valve adiuster handle and loosen the jam nut; then rotate the tappet adjuster screw
clockwise until friction is feltDAlign the valve adjuster handle with one of the marks on the valve adjuster dialEWhile holding
the valve adjuster handle in place, rotate the valve adjuster dial counterclockwise until specified valveltappet clearance
is attainedI NOTE: Rotating the valve adjuster dial counterclockwise will open the valveltappet clearance by 0.05 mm (0.002
in per mark 27Place the valve cover into positionINOTE: At this point, the rocker arms and adjuster screws must not have
pressure on them FWhile holding the adjuster dial at the proper clearance setting, tighten the jam nut securely with the