2005 Arctic Cat ATVs factory service and repair manual, Page 327Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 327

I NOTE: Support the connecting rod with rubber bands to avoid damaging the rod or install the Connecting Rod Holder (pln
it out of the dome of the groove CT AT THIS POINT To service piston, see Servicing Top-Side Components sub-section CT AT
THIS POINT To service center crankcase components only, proceed to Removing Left-Side Components Left-Side Components I NOTE:
For efficiency, it is preferable to remove and disassemble only those components which need to be addressed and to service
only those componentsThe technician should use discretion and sound judgment 2Remove the flange nut securing the starter
cup to the crankshaft; then remove the starter cupAccount for the O-ring inside the cup CT AT THIS POINT To service any one
specific component, only limited disassembly of components may be necessaryNote the AT THIS POINT information in each sub-sectionto
be removed from the frame for this procedureI NOTE: The engineltransmission does not have 3Put the shift lever into the hi-range