2005 Arctic Cat ATVs factory service and repair manual, Page 340Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 340

9Remove the driven gear from the crank balancer assembly (A)Account for key 5Remove the three remaining forks noting their
the driveshaft andor countershaft are not being serviced, it is preferable to leave them assembledThe technician should use
discretion and sound judgment I NOTE: There is flat spot on the crank balancer to allow clearance past the crankshaft 11Using
the Crankcase SeparatorICrankshaft Remover (pln 0444-009), push the crankshaft assembly out of the crankcase 8Remove the
front output shaft (J) and rear shaft assembliesAccount for the bearing C-ringI NOTE: Note the alignment marks on the crank