2005 Arctic Cat ATVs factory service and repair manual, Page 341Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 341

Do not remove the remaining output shaft assembly unless absolutely necessaryIf the shaft is removed, the shaft nut must
light pressure, move the valve cover in figure eight motionInspect the sealing surface for any indication of high spotsA
high spot can be noted by bright metallic finishCorrect any high spots before assembly by continuing to move the valve cover
in figure eight motion until uniform bright metallic finish is attained Table of Contents (Servicing Components) I NOTE:
Critical engineltransmission specifications are located at the beginning of this section Servicing Top-Side Components 3-287
Valve Assembly 3-287 Piston Assembly 3-291 CylinderICylinder Head Assembly3-293 Servicing Left-Side Components 3-296 Recoil
Starter 3-296 Measuring Shift Fork (Thickness) 3-299 Measuring Shift Fork Groove (Width) 3-300 Measuring Shift Fork To Groove
(Side Clearance) 3-300 Servicing Right-Side Components 3-300 Primary Clutch Assembly 3-300 Inspecting Oil Pump 3-302 Servicing
Center Crankcase Components .3-303 Secondary Gears -303 Crankshaft Ass -304 Driveshaft 3-305 Countershaft 3-312 Do not remove