2005 Arctic Cat ATVs factory service and repair manual, Page 342Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 342

Removing Valves I NOTE: Keep all valves and valve components as setNote the original location of each valve set for use during
the valve seal 1Using micrometer, measure the valve stem outside diameter 2Acceptable diameter range (intake valve) must
be within specifications3Acceptable diameter range (exhaust valve) must be within specificationsMeasuring Valve FaceISeat
Width 1Using micrometer, measure the width of the valve face 2Acceptable width specifications Measuring Valve Face Radial
Runout I NOTE: The valve seals must be replaced 1Mount dial indicator on the surface plate; then place the valve stem on
set of blocks2Position the dial indicator contact point on the outside edge of the valve face; then zero the indicator- 3Remove