2005 Arctic Cat ATVs factory service and repair manual, Page 343Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 343

Replacing Valve Guide IIf valve guide is worn or damaged, it must be replaced 1If valve guide needs replacing, insert valve
the indicator2Using the Standard Valve Guide Reamer (pln 0444-017), remove any burrs or tight areas from the valve guide
journals 3Push the valve from side to side; then from top to bottom4Maximum "wobble" deflection must not exceed specificationsMeasuring
Valve Guide (Inside Diameter) 3To install valve guide, use valve guide installer and gently drive valve guide with retaining
clip into the bore from the valve spring side until the retaining clip just contacts the cylinder head 1Insert snap gauge
112 way down into each valve guide bore; then remove the gauge and measure it with micrometer2Acceptable inside diameter