2005 Arctic Cat ATVs factory service and repair manual, Page 348Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 348

3Place the cylinder on the surface plate covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the cylinder
must be used in conjunction with the wet-or-dry sandpaper or W NOTE: Nickasil-plated cylinder cannot be honed Inspecting
Cam Chain Guide I Inspect cam chain guide for cuts, tears, breaks, or 4If any measurement exceeds the limit, hone the cylinder
and install an oversized piston or replace the cylinderW NOTE: Oversized piston and rings are availableThe oversized ist
ton and rinas are marked foridentification 2If the chain guide is damaged, it must be replacedHoning Cylinder 1Using slide
gauge and dial indicator or snap gauge, measure the cylinder bore diameter in three locations fi-om top to bottom and again
fi-om top to bottom at 90' fi-om the first measurements for total of six measurementsThe trueness (out-of-roundness) is the
difference between the highest and lowest readingMaximum trueness (out-of-roundness) must not exceed specificationsI Ring
Expander Measuring Camshaft Runout W NOTE: If the camshaft is out of tolerance, it must be replaced 1Place the camshaft on