2005 Arctic Cat ATVs factory service and repair manual, Page 357Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 357

Servicing Center Crankcase Components I NOTE: Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance,
half 2Clean the secondary driven bevel gear teeth of old oil and grease residue 1Place the left-side crankcase cover onto
the left-side crankcase half to prevent runout of the secondary transmission output shaft2Install the secondary driven output
shaft assembly onto the crankcase3Mount the indicator tip of the dial indicator on the secondary driven bevel gear 3Apply
thin, even coat of machinist-layout dye to several teeth of the gear4Install the secondary driven output shaft assembly5Rotate
the secondary driven bevel gear several revolutions in both directions 4While rocking the driven bevel gear back and forth,
note the maximum backlash reading on the gauge5Acceptable backlash range is 0.05-0.33 mm (0.002-0.013 inCorrecting Backlash
INOTE: If backlash measurement is within the acceptable range, no correction is necessary 6Examine the tooth contact pattern