2005 Arctic Cat ATVs factory service and repair manual, Page 372Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 372

INOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs Installing Right-Side Components AOil StrainerIOil
oil drain plug to specifications 7In crisscrosscase-to-case pattern, tighten the mm cap screws (from steps 3-4) until the
halves are correctly joined; then tighten to specificationsINOTE: Rotate the shafts back and forth to ensure no binding or
sticking occurs 8In crisscrosscase-to-case pattern, tighten the mm cap screws (from steps 5-6) to specificationsINOTE: Rotate
the shafts back and forth to ensure no binding or sticking occurs 3Place the oil pump into position in the crankcase and
secure with the three Phillips-head screws coated with blue Loctite #243Tighten to specifications After completing center