2005 Arctic Cat ATVs factory service and repair manual, Page 382Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 382

AInstall ring expander (4) in the bottom groove of the piston; then install the thin oil rings (3) over the expander making
The chrome (silver) ring should be installed in the top position 3Lubricate the inside wall of the cylinder; then using ring
compressor or the fingers, compress the rings and slide the cylinder over the pistonRoute the cam chain up through the cylinder
cam chain housing; then remove the piston holder and seat the cylinder firmly on the crankcase The cylinder should slide
on easilyDo not force the cylinder or damage to the piston, rings, cylinder, or crankshaft assembly may occur Incorrect installation
of the piston rings will result in engine damage 1Install the piston on the connecting rod making sure there is circlip on
each side and the open end of the circlip faces upwardsINOTE: The piston should be installed so the arrow points toward the