2005 Arctic Cat ATVs factory service and repair manual, Page 387Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 387

25Loosen the four adjuster screw jam nuts; then loosen the four adjuster screws on the rocker arms in the valve cover26Apply
then install the remaining cap screwsTighten only until snug 29In crisscross pattern starting from the center and working
outward, tighten the cap screws (from step 28) securely30Adjust valveltappet clearance using the following procedureIUse
Valve Clearance Adjuster (pin 0444-078) for this procedure ATurn the engine over until the piston reaches top dead center
on the compression strokeB, Place the valve adjuster onto the jam nut securing the tappet adjuster screw; then rotate the
valve adjuster dial clockwise until the end is seated in the tappet adjuster screw Page: 387 Arctic Cat ATV 2005 -All Models