2005 Arctic Cat ATVs factory service and repair manual, Page 396Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 396

21Remove the rear engine mount through-bolt; then remove the rear engine mount brackets from the frameINOTE: Removina the
ClutchIClutch Gear HOil Pump 23Raise the rear of the ensine and maneuver forward the Ear dIiqe coupler; then lower the rear
and shift the engine to the rear to release the front drive couplerINOTE: This will reauire an assistant to hold cables and
lines clear and to assist in maneuvering the engineltransmission assembly out of the frame 1Remove the four cap screws securing
the recoil starter assembly to the left-side cover; then remove the recoil starterAccount for the gasket2Drain the system
including the coolant reserve tank; then remove the coolant hoses (A), four cap screws 0, the water pump cover and (C)for
the gaskett 24Remove the engineltransmission assembly from the left side of the frameI NOTE: Tape over or cap all open hoses,