2005 Arctic Cat ATVs factory service and repair manual, Page 399Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 399

Removing Right-Side Components AV-Belt Cover BDriven Pulley CClutch Assembly Imbalance of clutch or driven pulley or excessive
learning control of the engine brake control to operate and the engine brake actuator may be damaged 1Turn the ignition switch
to the OFF position and remove the ignition key2Loosen the two clamps (A) securing the air duct boot (B); then remove the
boot5Remove the cap screw (left-hand threads) securing the clutch assembly 6Using an appropriate clutch puller, remove the
clutch assembly (A); then lift the V-belt (B) off the driven pulley (C)Note the direction of the printed information (D)
on the belt or mark the belt for correct installationSee Section for procedure 3Disconnect the belt failure detection connector