2005 Arctic Cat ATVs factory service and repair manual, Page 405Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 405

INOTE: The right and left crankcase halves are machined as an assembled set; therefore, they must be replaced as set INOTE:
serviceable side clearance is 0.7 mm (0.028 inConnecting rods or crankshaft will have to be replaced if measurement exceeds
specification 4Remove the shift shaft spring anchor (A); then remove the shift shaft (B) A CAUTIONConnecting rods are machined
with the big end caps installedSevere engine damage will result if the caps are not installed on their respective rods 5Remove
the spacer (B) and reverse drive gear (C) accounting for needle bearing and spacer; then remove the reverse idler shaft (A),