2005 Arctic Cat ATVs factory service and repair manual, Page 415Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 415

Place the cylinder on the surface plate covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the cylinder
cylinder boreIf the bore is severely damaged or gouged, replace the cylinder Water or parts-cleaning solvent must be used
in conjunction with the wet-or-dry sandpaper or Inspecting Cam Chain Guide 4If any measurement exceeds the limit, replace
the cylinderMeasuring Camshaft Runout I NOTE: If the camshaft is out of tolerance, it must be replaced 1Inspect cam chain
guide for cuts, tears, breaks, or chips 2If the chain guide is damaged, it must be replacedHoning Cylinder 1Using slide gauge
and dial indicator or snap 1Place the camshaft on set of blocks; then position the dial indicator contact point against the
shaft and zero the indicator gauge, measure the cylinder bore diameter in three locations from top to bottom and again from
top to bottom at 90' from the first measurements for total of six measurementsThe trueness (out-of-roundness) is the difference