2005 Arctic Cat ATVs factory service and repair manual, Page 417Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 417

Servicing Right-Side Components I NOTE: Whenever part is worn excessively, cracked, damaged in any way, or out of tolerance,
pin (B) is not broken, chipped, or worn flatI NOTE: Do not remove shaft (A) or pin (B) as they are not serviceable and cannot
be reassembledThe camshaft assembly must be replaced if any defects are found 2Place the driven pulley assembly onto the
compressor tool base 3Tighten the nut against Spring Holder (pln 0444-162) (C) to compress the springs; then using circlip
pliers (B), remove the circlip (A) Servicing Left-Side Components RECOIL STARTER INOTE: The recoil starter is non-serviceable
componentIf it is damaged or if it does not function properly, it must be replaced as complete unit 4Relax the spring by