2005 Arctic Cat ATVs factory service and repair manual, Page 422Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 422

4Install the spring spacer in the spider; then install the spring (A) in the spider groove 2Maximum diameter specifications
Servicing Center Crankcase Components CRANKSHAFT ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter) 4Measure the
crank pin diameter (A) and check the crankshaft marking (B)If no mark is on the crankshaft, the crank pin diameter should
be within specificationsIf the crankshaft is marked with "0," crank pin diameter should be within specificationsIIf the crank
pin diameter does not coincide with the marking, make new mark that coincides with the measurement 1Insert snap gauge into
the upper connecting rod small end bore; then remove the gauge and measure it with micrometer Page: 422 Arctic Cat ATV 2005