2005 Arctic Cat ATVs factory service and repair manual, Page 423Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 423

5Measure the connecting rod big end inside diameter; then check the mark (A) to see if the measurement coincides with the
plate7Slowly turn the crankshaft and note the readings at the noints indicatedCrankshaft runout must be less than specifications
DISASSEMBLING OUTPUT DRIVE BEVEL GEAR ASSEMBLY C AT THIS POINT If no abnormal wear, chipping, or bearing roughness is found,
proceed to Installing Output DriveIDriven Bevel Gears in this sub-section 1Look through the bolt hole (B) in the drive housing
(A); then rotate the drive bevel gear (C) until notch in the inner bearing retainer nut can be seen 8Measure the crankshaft