2005 Arctic Cat ATVs factory service and repair manual, Page 425Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 425

DISASSEMBLING OUTPUT DRIVEN BEVEL GEAR ASSEMBLY AT ? 4Hold the housing assembly (A) with the output shaft holder (B) and
(A) on the holder, tighten holder nuts (D), and compress the damping spring (E) 5Using special deep socket (B), remove the
output shaft retainer nut (A) 2Remove the circlip (A); then loosen and remove the holder nuts and spring compressor component
of the tool 3Remove the spring holder (B), spring (C), cam damper (D), and the driven bevel gear (E)6With the housing assembly