2005 Arctic Cat ATVs factory service and repair manual, Page 426Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 426

3Install the rear cylinder camshaft chain guide (A) and tighten bolt (B) to specifications Assembling Crankcase Half mNOTE:
therefore, they are matched pairUsing unmatched crankcase halves will result in severe engine damage 1Using press, install
ball bearings (A) and (B) into the crankcase making sure that the seal on bearing (B) is directed toward the crankcase; then
press in needle bearings (C) and (D) until flush with bore (insert bearing (D) fi-om the outside)2Install the oil pressure
relief valve (E); then coat all bearings with clean engine oil 5Apply grease to the lip (A) of the crankshaft oil seal (Bl: