2005 Arctic Cat ATVs factory service and repair manual, Page 427Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 427

6Select connecting rod big end inserts using the following chart and the markings on the crankshaft and connecting rod 7Install
must be 0.028-0.052 mm (0.0011-0.0020 in standard with maximum service limit of 0.09 mm (0.0035 in 9Clean off all traces
of plastigauge from the crankshaft and inserts; then assemble on the crankshaft using clean, molybdenum disulfide oil on
the inserts (A)Make sure that the "OUT" marks (B) on both connecting rods are directed towards the outside of the crankshaft
and the grooves (C) of the cap and connecting rod are on the same side 0Install the crankshaft assembly in the right crankcase
half1Using press, install the driven shaft in the crankcase until it is bottomed; then install the needle bearings (B) on