2005 Arctic Cat ATVs factory service and repair manual, Page 431Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 431

15Secure the holding fixture (A) in vise; then install the driven bevel gear (C), cam damper (D), spring (E), spring holder
the circlip, remove the nuts (C), compressor (B), and guide rods (A)Apply grease to the O-ring seal on the housing 12Secure
the output shaft holding fixture (B) and spacer (C) in vise; then hold the housing assembly (A) and install the output shaft
(D) in the housing13Apply blue Loctite #242 to the threads of the output shaft retainer nut (E) and with the protruding side
(F) directed away from the bearing, tighten to specifications 17Install the driven gear assembly (B) in the crankcase; then