2005 Arctic Cat ATVs factory service and repair manual, Page 432Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 432

r Adjust gear backlash Adjust tooth contact pattern Assemble the output bevel gear completely ATV2092 18Install the drive
new reading is the backlashIt should be between 0.05-0.11 mm (0.0020-0.0043 in I NOTE: If any of the output bevel gear (backlashrelated)
parts have been replaced, the Adjusting Backlash and Adjusting Tooth Contact procedures must be followed I NOTE: To decrease
backlash, decrease the thickness of shims (7)To increase backlash, increase the thickness of shims (7)Make small changes