2005 Arctic Cat ATVs factory service and repair manual, Page 435Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 435

29Install the position plate (A); then tighten cap screws (B) to specifications 32To prepare the intermediate shaft chain
33Secure the chain tensioner assembly (A) to the crankcase with cap screws (B); then tighten to specifications and remove
the wire (C) 31Place the rear intermediate chain guide (A) onto the pivot as shown; then secure with flat washer (B) and
circlip (C) 34Apply grease to the O-ring (A); then install the cover (B) into the right side of the crankcase with the tapped