2005 Arctic Cat ATVs factory service and repair manual, Page 436Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 436

2Install the two bevel washers (A) with the concave side directed towards the driven pulley; then use the pulley holder (B)
the driven pulley on the transmission driven shaft (A) being careful not to jam the splines (B) with the splines in the pulley
(C) 3Loop the belt over the driven pulley; then install the drive clutch with holding tool (A) with cap screws (B) referenced
to the arrow (D) and tighten the cap screw (C) (left-hand threads) to specifications 4Check that drive belt deflection is