2005 Arctic Cat ATVs factory service and repair manual, Page 463Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 463

ADJUSTING FLOAT HEIGHT 1Drain all fuel from the carburetors; then remove the screws securing the float chamber and remove
pivot pin (B) out and remove the float (C) 11Use tape to cover and seal the intake tubes 3Bend the float valve contact tab
(A) slightly to adjust float height Any objects or liquid entering the intake tubes will fall into the engine causing severe
damage if the engine is turned over or started 4Measure the float height (A) from the float chamber mating surface (B) by