2005 Arctic Cat ATVs factory service and repair manual, Page 465Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 465

ASSEMBLING - Do not force or overtighten carburetor jets and fittingsDamage to the jets or carburetor could occur 5Install
and slow jet3Insert the jet needle (A) into the vacuum piston (B); then install the spring seat (C) over the needle 7Place
the float chamber into position making sure theO-ring is- properly positioned; then secure with -Phillips-head screws INSTALLING
4Turn the spring seat (A) so it does not block the vent hole (B) 1Lay the carburetors on top of the engine; then install
the starter plungers and secure with the retainer screws2Connect vent lines; then connect the coolant hoses and secure with
appropriate clamps 3Remove the tape or covers from the intake tubes and insert the carburetor into the intake tubes making